You may have noticed in the photo of the extinguisher for the cabin that I have seat covers from BSmooth. I think this was also the first set he has done with the "O" rings in it to match the ones in the seats. I just installed them, so it will take a while for them to "sit down", but the "O" rings match up perfectly with the ones on the seat. I have always found the ones in the seat to be a little uncomfortable. I had 1" foam sewn into the bottom and back sections to make it a little more comfortable. This turned out to be a good idea as now that the the Penskes are on it is definitely a stiffer ride. I did not have slots cut in the covers for the harnesses, as will I remove the seat covers and sit down on the seats directly for track use. Another benefit of the "tweed" BSmooth seat covers is that they go very well with all the carbon compenents from Kip Ewing. I know it doesn't show in the picture too well, but in person the pattern of the fabric "matches" the pattern in the carbon fiber. The fit and finish of the seat covers from BSmooth is top notch, and I highly recommend them.
Here is also a photo of Kip's carbon fiber gauge cluster piece along with freeflyer's boost gauge installed. I've got a set of full door panels on order from Kip along with the pocket inserts where the switches are. I can't wait to see the entire door panel covered in carbon fiber. That's really going to look bitchin.
