twobjshelbys
GT Owner
Everything these days is just-in-time inventory. Mine was about a month old.Aren't the Ford logoed batteries built to order and therefore more fresh than something off the shelf?
Everything these days is just-in-time inventory. Mine was about a month old.Aren't the Ford logoed batteries built to order and therefore more fresh than something off the shelf?
Other battery options available. PM meAren't the Ford logoed batteries built to order and therefore more fresh than something off the shelf?
I have had the car since new 2006 Ford GT titanium/ silver stripes and now have 7600 miles. No issues previously but took the car in for airbag replacement a month a go and they said that they changed both airbags. I have had the car in storage on a battery tender the whole time and got a call from Ford performance asking me to take the car in for the airbag recall and I said I did. They said they only show that the drivers side was changed. I subsequently found out that the dealer put in the wrong airbag so I took it in again for them to replace the passenger side. Upon leaving the dealer the entire instrument cluster was dead. I restarted the car and it worked OK but after several attempts it showed dead. I returned the car and they said that the guage cluster module was faulty and needed to be changed at the cost of $8700 plus labor totaling about $10,000.
THEY SAID THAT IT WAS JUST A COINCIDENT THAT THE FAILURE OCCURED AFTER THE AIRBAG WAS CHANGED FOR THE SECOND TIME ! I DONT WANT TO USE AFTER MARKET AND REFURBISHED PARTS BUT I AM PISSED ABOUT THIS SINCE IT WAS FINE BEFORE THE AIRBAG EXCHANGE. Is it possible there was a voltage surge or a short when they changed the airbag? nI was going to call the Ford assistance line and ask for help.
It's too bad the dealer service guys arent aware of the battery / gauge link$250 vs $10,000....this forum is worth it!!!
I just had the air bag recall performed on my 05 GT all of a sudden the fuel gauge stopped working.
Ordered and received replacement gauge. Wanting to install myself. Removed small screws holding gauge panel. Panel is loose but doesn't want to come out Whats the trick in getting it out? Help please.