exhaust messurements needed

[Jason Watt]

Hi there.
My car is in peaces and when going back together it will get the bumper delete job.
I have an Accufab x-pipe and when cutting it down in lenght I would like to add some tips to it, but I'm not sure there is enough room due to the shape of the tubes.
Would some one with a bumper delete exhaust like in the link below please messure the length from the centerline om the mounting flange to the end of the top of the tips??
:thumbsup

http://www.hellotrade.com/cool-tech-clarinda/ford-gt-bumper-delete-exhaust.html

 

[Shadowman]

Hello

Tips such as shown in the picture can be used however you will have to fish month the upper portion of the tip and then hand fit them; tack them in place and then lift the assembly out and complete the perimeter weld.

Takes care

Shadowman

 

[Jason Watt]

I'm now plannning to have the exhaust made from scratch and the tips I'll use are bigger than the ones in the link.
So messurements would be grately appriciated.

 

[Shadowman]

You shared that you were using an AccuFab X pipe; did I miss something?

Shadowman

 

[Jason Watt]

You're right Bill but since my first post I decided to make a new exhaust :wink
But still would like to get info as asked in the first post.

Thanks