Rear Badge for the GT

[Viper 1]

I'll take one also. Ken

 

[KERRY P]

I will take one Ken, THANK YOU!!!!

 

[06fordgt]

so far I count 21. So I'll take 2 to make 23.

 

[JCE-GT]

AZGT,

Please add me to the list too, I'm good for one.

JCEGT

 

[AZGT]

I have everyone listed so far (site and PM). I'll give it another day or two in case anyone else wants one. I'll also order a couple extra "just in case."

I did contact the vendor regarding an additional order, and the number is in line what I told them to I would expect, so I don't forsee any problem.

I will place the order in a couple of days, then PM everyone when they come in regarding payment, addresses, etc.

 

[Desi]

Me too, please!
Desi

 

[SteveA]

Ditto please!

 

[FrankBarba]

glad i stopped by today....i'll take 2 please.

 

[Lgaruti]

AZGT One for me also...

 

[gtjim]

I'll take two if you're still taking orders! One for the current GT, and one for the next one - just in case.

 

[AZGT]

Order

I will go ahead and put in the order for everyone up to this point and see what happens. Should be OK. I will get two extra in case anyone else wants one.

I'll PM everyone when they come in.

 

[SYCO GT]

I would like one (1) badge please. How do they mount?

 

[AZGT]

OK.

I can add you in.

Two pins that go though the grill and speedy nuts (plus washers).

No drilling, etc.

 

[AlohaGT]

Please count me in for one, if I'm not too late.

 

[PRDATR]

I'll take two if its not too late.:thumbsup

 

[AZGT]

I don't know. I'll see if they can still get in.

 

[Cobrar]

Thank You!!

Larry,

Received the badge today. Quality control & packaging team performance was excellent :thumbsup (all hardware and instructions included) as per design. Probably a winter installation, some custom painting of the to match the (Red) car.

Thanks again! Rex

 

[paulo5656]

I wil take two if available

 

[roketman]

Got Mine Today ,looks Great .all Ready On The Gt Thank You !!!!!!!!!!!!!!!!

 

[Midnite Blu]

Recieved & Installed, Thanks AZGT

Great looking. Just a hint for install, cut half inch off pins first and open nuts so they fit on pin to start threads. Not too tight.......Thanks again AZGT. :thumbsup :thumbsup