Search results

Looking for 2005/2006 FORD GT Tachometer. Not working is just fine. Let me know if you have one. Thanks

I believe the 2004 F-150 is a real close match. I believe it's just the location of the switch that is different. attached is a photo. Same supplier (Tokico) and "71" on the side. I've never tried it but always thought it's worth a shot if mine goes bad.

Looking for a used/new drivers door mirror. Damaged is ok too.

I keep a couple in stock. $120 shipped.

The 3U2Z 14S411 RNA Connector was a perfect fit. Thanks to all. I can now wire up an aftermarket stereo into the GT.

Also found on ebay using the 3U2Z 14S411 RNA parts number

GT@50 --Thanks much - it sure looks correct!!! Found on Amazon. Just ordered it. Love you man!

I'm one of the crazy guys that did the chassis group buy a few years ago so like several others, I'm building from parts again. So I collected as many McIntosh parts as I could but still missing the door harness wires that run between the crossover boxes and apparently the door speakers. I have...

Since I've been unable to located the rest of the door harness's (parts not even listed in parts book) to make my McIntosh Stereo build complete, I'm going to try to fit an aftermarket radio in the car. The blue connector is McIntosh; the Gray connector is for base radio. I've been unable...

Mark - I will take it. I'll send you a PM.

poopies.....I have been looking for one of these :confused:

Sold

One owner loaded 2010 Fusion Sport owned by Ford GT Engineer. 3.5L 24V V6 Duratec Engine / 6 speed selectshift auto trans. Always maintained in excellent condition, always garaged, rarely driven in rain or snow. 3K mile oil changes, new Goodyear top of the line tires, brakes, all recall's up...

It was a good day for a drive and a coffee!

sent PM.....

I'm bringing my '05 Coyote Powered Ford GT.

I suppose it's the challenge of the build. For those that built model cars and airplanes when they were kids will get it. Some guys want to built their own track / custom car and not butcher up a perfectly good GT. Others bought entire powertrains and supporting hardware from crashed GT cars...

There are several of us working on building our cars. Slow process but collecting up parts and working away.

When I was working on the GT Program, I had a similar thought; cut the frame rails short (or make my own) and have a body colored snap-on cap (3D printed?). That way you can use al the stock based parts.

Was hoping Santa would leave me a Gauge Module (goes in the IP on the LH side) in my stocking; need it to complete my latest build but no luck. And I was good this year!