Search results

I'm "feeling" tie rods...

Alignment is checked/good...but all rubber is original. I will inspect for leaks/rips/tears.

I think it looks like my Heffner...BUT hard to see the pipe joint in the middle.

How did you find/discover the break?

Thanks all...looking for some way to test/inspect too.

Even at 30 psi per side.

I will check...I normally keep 30 psi in the "stones".

My 2006 GT (with 46,000) is starting to (ever so slightly) pull right as the nose comes up under acceleration...and comes back down to the left when I let off the gas (but not under braking as far as I can tell). I am searching the forum BUT thought that some of the higher mileage members could...

Any updates on why this might have happened?

PM'd you.

My recent research and understanding (which hopefully will be corrected if wrong) was that Ford had some fast (and it turns out intermediate) but less than adequate solutions until late (Dec) 2007. Ford "final solution" was a kit designated part #4G7Z-4B490-A. This morning I got a helpful Ford...

All good information...Thanks Kendall/Ryan

Please correct me if I am wrong but my research says the Ford "final solution" was part #4G7Z-4B490-A. I have gotten my local Ford Dealer to dig into the Oasis system and determine that the service done in Dec. 2007 included this part # (see attached)...so I feel I'm good to go. Agreed?

100% agree...like mudding drywall, safety wiring is an ART!

I am not a Monterrey expert (only been once), but my experience during Pebble Beach was mostly sitting in traffic in my rental car.

It has NOT changed!

Thanks, I have Heffner's H-pipe and had forgotten about them...although "a few hours" turns out to be 550 miles away (ONLY 2 hours, 45 minutes at top speed-as I am right near to the Florabama Bar).

My recommendation is buy GTJoey's book too.

Thanks all! (I read all 12 pages of the CSP-transaxle bolts) For those who lived through this, it looks like the FINAL SOLUTION Ford fix was part #4G7Z-4B490-A On my paperwork above I do not see that # called out? Does anyone know if this might be available from Ford? So it looks like I...

Might any of the experts be able to look at my paperwork above and determine if I have any reason to be concerned about my axle bolts? Thanks!l.p.