Recent content by analogdesigner


  1. analogdesigner

    Center Caps for optional forged BBS wheels

    Yes, I'll take a set!
  2. analogdesigner

    California Insurance Suggestions

    I switched to Hagerty a few years ago. I'm in S. California. Jay
  3. analogdesigner

    Leather conditioner recommendations?

    Leatherique has worked well for me.
  4. analogdesigner

    Engine wire harness on backorder

    Gerry, can you get the terminals in non-gold plated form? These could be sent out for gold plating. Jay
  5. analogdesigner

    Oil pressure gauge fluctuation - Yes, another one

    I sent you a message! Jay
  6. analogdesigner

    Oil pressure gauge fluctuation - Yes, another one

    extrap, this looks like a bad sender as those are the same symptoms that I had. I am on my second replacement. I may have a new sender as I wanted a backup. Here is a graph that I did showing oil pressure versus RPM. This was done at operating temperature with the factory recommended oil. Jay
  7. analogdesigner

    change oil in ford gt 2005

    Sometimes when cranking the engine, the battery voltage is too low for the oil pressure gauge to "boot up." I confirmed this a long time ago using an external power supply.
  8. analogdesigner

    Just moved to SoCal

    Jason, in San Clemente we have the world's largest weekly car show every Saturday morning. Stop by sometime. Jay
  9. analogdesigner

    Michelin tire question size matching the Bridgestone

    If anyone located in the western USA needs Bridgestone tires, contact Jim Fogelquist; [email protected] Jay
  10. analogdesigner

    RIP Bob Bondurant

    I'm processing some photos for Davis Motorsports. Here is a photo of Bob Bondurant and my friend Don Davis back in the 1970s. This is Don's Ford GT40 MkII, chassis P1012 that he meticulously restored after Peter Revson had a bad crash in 1967. Bob and Don drove this car in numerous races. Jay
  11. analogdesigner

    Interesting article about the control arm recall

    I remember seeing some early GTs at the dealer with "billet" machined arms. Roush did the machining of these in a timely manner. Aluminum Precision Products in Santa Ana, CA did the forgings for the balance of the production cars. It's hard to beat a good forging!
  12. analogdesigner

    ‘06 McIntosh stereo issue

    I was told by a person at McIntosh (around 2005) that there was an antenna amplifier next to the antenna. Now that was when they were at Ford testing their prototype audio system and I don't know if the production cars had that. I will look at my notes from back then.
  13. analogdesigner

    Ford GT's Getting Flagged by CARB!

    So over a year later I finally got my car to a Referee Station to get it inspected. I live in (Southern) California so the Referee Stations are located at community colleges throughout the state. I did some research and I was allowed to pick a location of my choice. There was one location...
  14. analogdesigner

    Graphene Coating

    It's total BS!