Shim Kit
- Thread starter S592R
- Start date
Neilda
GT Owner
- Dec 3, 2006
- 2,800
BINGO! Give that man a quipee doll! :lol thought someone said somebody was doing aftermarket shims in kits. You need up to 5-6 pairs per corner ... depending on what setup you are running and at 18-25.00 a pair it gets nuts fast. especially since there is three different sizes ... so thats 18 pair sets a corner for a full kit. (if memory serves me correctly ...)
Not a big deal if your local source stocks them .. if they don't they usually want you to buy them when ordered.
Camber Shims
color coded for thickness. Two per wheel. 3 different thincknesses available through Ford, I believe. I have no data on thickness matched to color yet, but I can say there is a Red and a blue. And I can say I am after slightly more positive camber as my tires are cool on the outer edges after hot laps. Plan to talk it over with Rich and Denis in southern Maryland at the garage of PE2UNIA in a couple of weeks.
Pete S.
color coded for thickness. Two per wheel. 3 different thincknesses available through Ford, I believe. I have no data on thickness matched to color yet, but I can say there is a Red and a blue. And I can say I am after slightly more positive camber as my tires are cool on the outer edges after hot laps. Plan to talk it over with Rich and Denis in southern Maryland at the garage of PE2UNIA in a couple of weeks.
Pete S.
tmcphail
GT Owner/Vendor
STORMCAT
GT
- Aug 25, 2006
- 4,436
There are 6 parts numbers and the shims are different for the front and the rear and yet they are available in the same red, blue, black for both ends of the gal
The sizes are as follows;
Front black = 2mm
Rear black = 4mm
Front blue = 3mm
Rear blue = 5mm
Front red = 4mm
Rear red = 6mm
I hope that this helps
Takes care
Shadowman
The sizes are as follows;
Front black = 2mm
Rear black = 4mm
Front blue = 3mm
Rear blue = 5mm
Front red = 4mm
Rear red = 6mm
I hope that this helps
Takes care
Shadowman
Attachments
- Aug 25, 2006
- 4,436
Hi Pete
On the rear you can stack shims just verify that the bolt inserts far enough and then on the front for the same results you are removing thickness.
FYI: the combination that you shared will work fine.
If you create a stack that you are confident will remain then the idea of creating a solo shim would be easy enough .
Takes care
Shadowman
BlackICE
GT Owner
- Aug 25, 2006
- 4,436
Last edited:
BlackICE
GT Owner
BlackICE
GT Owner
The stock shims have 360 degrees of support a slotted shim has less engagement. Is this significant? I don't know, nor do I have the skills to analyze it. Therefore I will stick to the stock style shims to remove any doubts.
fjpikul
GT Owner
Pete, you need to send a PM to CobraR1939 (Wally). He comes up with some pretty trick items, but he hasn't been on the Forum much lately.
JCSB
Ex GT Owner
Is this possible?
Pete S.
Pete,
I have a wire edm in my shop which can easily create that design. Since with a wire edm you can easily stack the material up to 6" high I can produce large numbers without a problem and the stack can have different thicknesses.
John
